Information 19 September 2016

TUBE & PIPE BENDING

Rate this item
(0 votes)

TUBE & PIPE BENDING INFORMATION

MANDREL BENDING

This form of bending generally is used for tighter radii in tube (typically 3D ie; the radius is 3 times the o/dia of the tube). It controls the flow of plasticizing material at the point of bend in order to maintain the shape of tube as it sets into the arc of the bend. 

  If the tube wall is thick enough relative to the overall size of the tube or if the specifications are not too severe (e.g., shallow depth of bend or a large "D" bend radius), then a mandrel may not be necessary, because the force of the bend is not sufficient to buckle or collapse the tube wall at the point of bend.  However, if the wall factor of a tube exceeds 20, a mandrel is needed in most instances. Asnkar can mandrel bend tube up to 76mm diameter.

The key to effective use of the mandrel is to set its nose so that it supports as much of the point of bend as possible (see below). This ensures that the vertical cross-section of the arc of the tube bend, while it is in a plastic state, will take the shape of the nose as the tubing material is drawn over it.  This plastic region of the tube bend extends both behind and ahead of the line of the tangency, therefore, the mandrel nose must be set forward of the line of tangency into the arc of the tube bend in almost all cases. 

The limiting factor of this forward placement is the point where the outboard line of the mandrel intersects with the tube wall of the outside radius; in other words, the point where the mandrel nose would literally stick out past the bend.  The location of this point can be determined by formula developed from the Pythagorean theorem.  Generally it is advisable to locate the nose (excluding the nose radius) about the two-thirds of the distance between this point and the line of tangency.  This will allow for slight flattening of the tube's cross-section at the outside radius, which unavoidably occurs because of the tension of the draw, without intersecting the mandrel nose.

Read 1635 times
Last modified on 26 September 2016

About Us

ASNKAR. Co. was founded in 1987 and started working on (used iron trading) .In1989 started working on manufacturing doors, window frames, fences and building supplies. Read more

 

Contacts

Address: South Industrial Zone

Erbil - Iraq

Tel: 009647504452081

Tel: 009647704452081

Tel: 009647507301726

Tel: 0662545061

Tel: 0662546051

Follow us

Facebook Page